Search results for 'sand'

Items 1 to 10 of 26 total

per page
Page:
  1. 1
  2. 2
  3. 3

Set Ascending Direction
  1. Brass Slotted Vents

    Brass Slotted Vents

    Brass self-cleaning taper-slot Vents. Slots diverge towards underface. Effectively prevents sand clogging. Concave underface provides maximum support to vent face.


    Learn More...
  2. Olivine Sand

    Olivine Sand

    Olivine Sand.


    Learn More...
  3. Resin Coated Sand

    Resin Coated Sand

    Resin coated sand for the Shell process.


    Learn More...
  4. Petrobond

    Petrobond

    CMS PETROBOND is a waterless moulding sand designed for use by the non-ferrous foundries to produce castings when extremely fine casting finish is desirable.

    It is supplied in a convenient, ready-for-use form. As it is a non-drying oil based sand mix, it can be readily reclaimed and reused several times after casting and knock-out operations.
     


    Learn More...
  5. Silica Sand

    Silica Sand

    Near white, high purity silica sand widely used for foundry casting and mould making. Firmly established as the best sand in New Zealand for this purpose.

     


    Learn More...
  6. Furan

    Furan

    Introduction
    SQG series No Bake Furan Resin is a kind of environmentally friendly foundry binder.

    Different types of resins can be used for steel casting, iron casting and non-ferrous casting. They appear pale yellow to red brown transparent liquid with the following characteristics:

    •    Low viscosity increases the speed of resin addition and the fluidity of moulding sand.

    •    Low free Formaldehyde content and less odour. This improves working condition and lightens environmental pollution.

    •    High strength reduces resin addition ratio, which means lower cost and higher quality of castings.

    •    Good collapsibility, high precision of casting with clear-cut and clean surface reduces the workload for cleaning and improves work efficiency.
     


    Learn More...
  7. Mould Seal Strip

    Mould Seal Strip

     Soft brown plasticine like stip for sealing the joing line of hard sand moulds.  Can also be used for the likes of sealing filter prints etc.

    Available in diameters of 4.5 & 6mm in convienient 1kg rolls.


    Learn More...
  8. Parting Powder

    Parting Powder

    PARTING POWDER is a white, inert refractory mineral combined with a flow promoter and anti-caking additive for use on moulding patterns and core boxes to ensure easy removal of the sand.


    Learn More...
  9. CMS Spuncoat GW

    CMS Spuncoat GW

    CMS SPUNCOAT GW is a water based graphitic coating. It is
    used as a die-release-agent in the centrifugal casting process for ferrous and non-ferrous castings.
     
    It is formulated using a high purity crystalline graphite and selected inert refractory powders suspended in water using efficient suspension agents and wetting agents.

    CMS SPUNCOAT GW is supplied in a ready-to-use form and can be diluted with water if required to suit application method employed.
     


    Learn More...
  10. CMS Rezcoat

    CMS Rezcoat

    CMS REZCOAT is a low viscosity, solvent based core and mould coating for hardening most sand surfaces. It is specifically designed for Green sand and Silicate sand in both ferrous and non-ferrous applications.
     


    Learn More...

Items 1 to 10 of 26 total

per page
Page:
  1. 1
  2. 2
  3. 3

Set Ascending Direction